Fe3O4@离子印迹聚(St-HPMA-DVB)复合材料的合成及其对水中高氯酸盐选择性吸附

郑雯静, 闻自强, 孙美娜, 沈昊宇, 胡美琴

郑雯静, 闻自强, 孙美娜, 等. Fe3O4@离子印迹聚(St-HPMA-DVB)复合材料的合成及其对水中高氯酸盐选择性吸附[J]. 复合材料学报, 2019, 36(1): 234-244. DOI: 10.13801/j.cnki.fhclxb.20180530.004
引用本文: 郑雯静, 闻自强, 孙美娜, 等. Fe3O4@离子印迹聚(St-HPMA-DVB)复合材料的合成及其对水中高氯酸盐选择性吸附[J]. 复合材料学报, 2019, 36(1): 234-244. DOI: 10.13801/j.cnki.fhclxb.20180530.004
ZHENG Wenjing, WEN Ziqiang, SUN Meina, et al. Preparation of Fe3O4@ion imprinted poly(St-HPMA-DVB) magnetic composite and its selective adsorption to perchlorate[J]. Acta Materiae Compositae Sinica, 2019, 36(1): 234-244. DOI: 10.13801/j.cnki.fhclxb.20180530.004
Citation: ZHENG Wenjing, WEN Ziqiang, SUN Meina, et al. Preparation of Fe3O4@ion imprinted poly(St-HPMA-DVB) magnetic composite and its selective adsorption to perchlorate[J]. Acta Materiae Compositae Sinica, 2019, 36(1): 234-244. DOI: 10.13801/j.cnki.fhclxb.20180530.004

Fe3O4@离子印迹聚(St-HPMA-DVB)复合材料的合成及其对水中高氯酸盐选择性吸附

基金项目: 国家自然科学基金(51608479;81502421);浙江省自然科学基金(LY14B04003);宁波市自然科学基金(2018A610206);国家级大学生创新创业训练计划项目(201713022009);宁波市新苗计划项目(甬教基2016-415)
详细信息
    通讯作者:

    沈昊宇,博士,教授,研究方向为功能材料及其应用,E-mail:hyshen@nit.zju.edu.cn

  • 中图分类号: TB332

Preparation of Fe3O4@ion imprinted poly(St-HPMA-DVB) magnetic composite and its selective adsorption to perchlorate

  • 摘要: 采用超声协助悬浮聚合法以高氯酸根(ClO4-)为模板制备了Fe3O4@离子印迹聚(苯乙烯-3-(2-氨基三乙基四胺)-2-甲基丙烯酸羟丙酯-二乙烯苯)(Fe3O4@ⅡP(St-HPMA-DVB))磁性复合材料,通过TEM、振动样品磁强计(VSM)、TGA、XRD、元素分析(EA)、FTIR等对其进行表征,考察了交联剂DVB用量对材料结构与性能的影响。结果表明:合成的Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料平均粒径为500~2 000 nm,随DVB用量的增加而增大;磁化强度为9.77~12.78 emu/g,随DVB用量的增加而减小;DVB的加入有利于Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料的离子印迹空腔的形成和稳定。考察了不同溶液pH值、ClO4-的初始浓度、吸附时间等条件下Fe3O4@ⅡP(St-HPMA-DVB)吸附水中ClO4-的性能,发现溶液pH值能显著影响Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料对ClO4-的吸附效果,pH为3.0时效果最佳;不同DVB用量Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料对ClO4-的吸附量和选择性有影响,当DVB用量为0.5 g时,Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料的吸附量和选择性最佳;吸附机制以离子交换和静电引力为主。等温吸附线符合Langmuir模型,Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料的饱和吸附量(qm,c=76.9~111.1 mg/g)高于非离子印迹材料Fe3O4@非离子印迹聚(NIP)(St-HPMA-DVB)磁性复合材料(qm,c=62.5 mg/g)。吸附过程可在10 min内达到平衡,符合准二级动力学模型;Fe3O4@ⅡP(St-HPMA-DVB)磁性复合材料能高选择性地有效吸附水中ClO4-,对ClO4-的印迹因子α为1.8,对几种常见共存离子的选择性因子β>5.8,是潜在的高选择性吸附和回收ClO4-的功能材料。
    Abstract: A Fe3O4@ion imprinted poly(Styrene-3-(2-amino triethylenetetramine)-2-hydroxypropyl methacrylate-divinylbenzene) (Fe3O4@ⅡP(St-HPMA-DVB)) magnetic composite was synthesized via ultrasonic assisted suspension polymerization with perchlorate (ClO4-) as the ion imprinting template. The Fe3O4@ⅡP(St-HPMA-DVB) magnetic composite was characterized by TEM, vibrating sample magnetometer (VSM), TGA, XRD, elemental analysis (EA). The effect of the usage amount of crosslinking agent DVB while preparation on the structure and performance of Fe3O4@ⅡP(St-HPMA-DVB) magnetic composite was investigated. The results show that the Fe3O4@ⅡP(St-HPMA-DVB) magnetic composite has an average size of 500-2 000 nm, which increases with the increase of the amount of DVB. The saturation magnetization intensity is 9.77-12.78 emu/g, which decreases with the increase of the amount of DVB. The addition of DVB is beneficial to the formation and stability of the ion imprinted cavity of Fe3O4@ⅡP(St-HPMA-DVB) magnetic composite. The effects of solution pH value, initial concentration of ClO4-, and adsorption time on the adsorption properties of ClO4- in aqueous solutions were investigated. The results show that the adsorption capability is affected significantly by solution pH value and reaches the maximum at pH=3.0. The best adsorption capacity and selectivity of Fe3O4@ⅡP(St-HPMA-DVB) magnetic composite to ClO4- can be obtained when the usage amount of DVB is 0.5 g for synthesis. The adsorption mechanisms may be including both ion exchange and electrostatic interaction. The isothermal adsorption curves mainly obey the Langmuir mode with the maximum adsorption capacity (qm, c=76.9-111.1 mg/g) much higher than that of none-ion imprinted polymer magnetic material Fe3O4@non-ion imprinted poly(NIP)(St-HPMA-DVB) magnetic composite (qm, c=62.5 mg/g). The adsorption kinetic studies show that the adsorption processes reach the equilibrium within 10 min and the kinetic data are well fitted to the pseudo-second-order model. There is almost no interference by the coexisting components in water for the adsorption of ClO4-, with imprinting factor α at 1.8, and selectivity factor β lager than 5.8 for several kinds of common co-existing anions, respectively. The Fe3O4@ⅡP(St-HPMA-DVB) magnetic composite is an ideal candidate for adsorption and recycle ClO4- from aqueous solution.
  • 期刊类型引用(17)

    1. 邱菊,恽定康,张宇,刘昌宇. 寒区相变蓄热墙体多因素热特性研究. 建筑节能(中英文). 2024(03): 126-131 . 百度学术
    2. 见禹,陈宝明,张明,尚荣真. 含穿孔翅片腔体中石蜡相变传热特性研究. 区域供热. 2023(01): 29-40+52 . 百度学术
    3. 肖鑫,冯泽,王云峰,张莹,高峰. 有机相变材料强化及耦合优化电池热管理系统的研究进展. 复合材料学报. 2023(07): 3795-3811 . 本站查看
    4. 于本田,陈延飞,李双洋,杨玉祥,胡柏春,刘涛. 正十四烷/石墨低温相变水泥基材料的制备及冻融损伤演化. 复合材料学报. 2022(06): 2864-2874 . 本站查看
    5. 郜伟军. 石墨对改性挤塑聚苯乙烯泡沫板导热性能的影响. 化工新型材料. 2022(S1): 374-376+380 . 百度学术
    6. 杜小泽,郭慧倩,王宇,杨立军. 蓄热式管壳换热器传热特性研究. 热科学与技术. 2021(03): 209-217 . 百度学术
    7. 冯晓平,郝学军. 强化三元混合熔盐的传热性能的实验研究. 无机盐工业. 2021(08): 66-70 . 百度学术
    8. 林肯,许肖永,李强,胡定华. 石蜡-膨胀石墨复合相变材料热导率研究. 化工学报. 2021(08): 4425-4432 . 百度学术
    9. 张佳利,丁宇,曲丽洁,何正斌,伊松林. 石蜡/膨胀石墨复合相变储热单元的放热性能. 储能科学与技术. 2019(01): 108-115 . 百度学术
    10. 徐众,黄平,吴恩辉,侯静,李军,刘黔蜀. 膨胀石墨/石蜡复合相变材料的电阻率分析. 储能科学与技术. 2019(02): 371-378 . 百度学术
    11. 李玉洋,章学来,Jotham Muthoka Munyalo,王迎辉,周孙希. 低温复合相变材料正辛酸-癸酸的制备及性能分析. 化工新型材料. 2019(05): 127-130 . 百度学术
    12. 李文虎,王志华,燕凌. 碳酸钙包覆石蜡复合相变材料在沥青混合料中的应用研究. 公路交通科技(应用技术版). 2019(11): 98-101 . 百度学术
    13. 张运华,刘芷怡,唐蓓莉,张冬丽,姚丽萍,闵捷. 高石蜡掺量相变水泥基复合材料的性能. 复合材料学报. 2018(04): 980-988 . 本站查看
    14. 王思宇,郭彦峰,余亮汉,张伟,李治纲. PEG/EG复合相变储能材料蓄冷性能的实验研究. 中国塑料. 2018(04): 51-57 . 百度学术
    15. 周英明,王封顺,吴国忠,李栋,刘昌宇. 含石蜡玻璃结构稳态传热过程理论和模拟分析. 建筑节能. 2018(10): 117-120+139 . 百度学术
    16. 王青青,范鹏远,陈玉明,吴志根. 膨胀石墨/石蜡复合相变材料热-电特性实验研究. 塑料工业. 2018(09): 129-133+137 . 百度学术
    17. 闫全英,张静,刘莎. 脂肪酸和石蜡复合相变材料导热系数的研究. 新型建筑材料. 2018(10): 68-71 . 百度学术

    其他类型引用(16)

计量
  • 文章访问数:  826
  • HTML全文浏览量:  91
  • PDF下载量:  219
  • 被引次数: 33
出版历程
  • 收稿日期:  2018-02-28
  • 修回日期:  2018-05-04
  • 刊出日期:  2019-01-14

目录

    /

    返回文章
    返回