陶瓷纤维长度对复合精铸型壳抗弯强度与透气性的影响及增强行为

芦刚, 纪超众, 严青松, 饶文杰, 郭俊

芦刚, 纪超众, 严青松, 等. 陶瓷纤维长度对复合精铸型壳抗弯强度与透气性的影响及增强行为[J]. 复合材料学报, 2017, 34(4): 865-872. DOI: 10.13801/j.cnki.fhclxb.20160720.001
引用本文: 芦刚, 纪超众, 严青松, 等. 陶瓷纤维长度对复合精铸型壳抗弯强度与透气性的影响及增强行为[J]. 复合材料学报, 2017, 34(4): 865-872. DOI: 10.13801/j.cnki.fhclxb.20160720.001
LU Gang, JI Chaozhong, YAN Qingsong, et al. Effects and enhanced behavior of ceramic fiber length on bending strength and breathability of composite shell for investment casting[J]. Acta Materiae Compositae Sinica, 2017, 34(4): 865-872. DOI: 10.13801/j.cnki.fhclxb.20160720.001
Citation: LU Gang, JI Chaozhong, YAN Qingsong, et al. Effects and enhanced behavior of ceramic fiber length on bending strength and breathability of composite shell for investment casting[J]. Acta Materiae Compositae Sinica, 2017, 34(4): 865-872. DOI: 10.13801/j.cnki.fhclxb.20160720.001

陶瓷纤维长度对复合精铸型壳抗弯强度与透气性的影响及增强行为

基金项目: 江西省自然科学基金(20142BAB216024);轻合金加工科学与技术国防重点学科实验室开放课题研究基金(gf201401004);航空基金(2015ZE56015)
详细信息
    通讯作者:

    芦刚,博士,副教授,硕士生导师,研究方向为液态金属精密成形理论及工艺,E-mail:aimulalg@163.com

  • 中图分类号: TB332;TG249.5

Effects and enhanced behavior of ceramic fiber length on bending strength and breathability of composite shell for investment casting

  • 摘要: 为了分析纤维长度对陶瓷纤维增强硅溶胶型壳抗弯强度与透气性的影响及增强行为,采用1~6 mm六种不同长度陶瓷纤维制备硅溶胶型壳试样。研究结果表明,陶瓷纤维长度对硅溶胶型壳强度和透气性的影响显著,随着陶瓷纤维长度的增加,型壳的抗弯强度先增大后减少,型壳的透气率先增大后减小再增大。当陶瓷纤维长度为4 mm时,型壳的常温及焙烧后抗弯强度达到最大值,分别为2.97 MPa和6.84 MPa;型壳的透气率达到最大值2.90。当陶瓷纤维长度大于4 mm时,纤维在型壳中分散性变差,纤维的桥联作用得不到有效发挥,型壳孔隙率减少,导致型壳强度和透气性变小。
    Abstract: In order to analyze the influence of fiber length on the bending strength and breathability of the ceramic fiber reinforced silica sol shell, the ceramic fibers with six different lengths from 1 mm to 6 mm were added to the silica sol slurry to reinforce shell. The results show that the length of the ceramic fiber has a significant effect on the strength and breathability of silica sol shell. With the increase of the ceramic fiber length, the bending strength of the shell increases first and then decreases, and the breathability of the shell increases first, then decreases and increases again. When the fiber length is 4 mm, the green strength and fired strength of the shell reach the maximum about 2.97 MPa and 6.84 MPa, respectively, and the breathability of the shell also reaches the maximum about 2.90. When the fiber length is more than 4 mm, the dispersion of fiber in shell gets worse, and the influence of fiber bridging is not obviously effective. The porosity of the shell reduces, which leads to the decrease of the strength and breathability of the shell.
  • 期刊类型引用(13)

    1. 张炳锋,高士武,杨晓林,刘柯楠. 聚乙烯醇纤维掺量对混凝土动态力学性能的影响. 青海大学学报. 2024(03): 64-70 . 百度学术
    2. 杨国梁,李峰,张志飞,毕京九,董智文,李影. 聚乙烯醇纤维混凝土动态断裂过程试验研究. 硅酸盐通报. 2023(02): 454-462 . 百度学术
    3. 朱俊涛,刘亚文,王娟,李可. 钢绞线网增强ECC与混凝土刻槽式界面粘结性能试验. 复合材料学报. 2023(05): 2913-2925 . 本站查看
    4. 陈宇,林熙杰,李长辉,吴堃,黄信. 抗收缩工程水泥基复合材料力学性能研究. 硅酸盐通报. 2023(05): 1599-1607 . 百度学术
    5. 李天伦,吴永根,吴豪祥. 低模量合成纤维对混凝土基本徐变的影响. 空军工程大学学报(自然科学版). 2022(03): 97-102 . 百度学术
    6. 霍海峰,刘汉磊,杨雅静,温升亮,李长辉,陈宇. ECC单轴拉伸疲劳变形特性及寿命预测. 复合材料学报. 2022(07): 3404-3414 . 本站查看
    7. 马晓宁,王娟. 纤维增强泡沫混凝土的性能试验研究. 合成材料老化与应用. 2022(04): 80-82 . 百度学术
    8. 徐亦冬,王瑶. 氧化石墨烯对水泥基复合材料徐变的调控机制. 复合材料学报. 2022(10): 4839-4846 . 本站查看
    9. 谢磊,李庆华,徐世烺. 纤维掺量对聚乙烯醇纤维增强水泥基复合材料动态压缩性能的影响. 复合材料学报. 2021(09): 3086-3100 . 本站查看
    10. 许永静,邓忠华,丁晓峰,邹黎明,王华君,安茂华. 大线密度高强高模聚乙烯醇纤维的制备及结构性能研究. 合成纤维工业. 2021(06): 6-11 . 百度学术
    11. 乔庆浩,李志华,张聪. 硅灰增强混杂纤维水泥基灌浆料与老混凝土粘结强度研究. 功能材料. 2020(06): 6143-6149 . 百度学术
    12. 张聪,夏超凡,袁振,李志华. 混杂纤维增强应变硬化水泥基复合材料的拉伸本构关系. 复合材料学报. 2020(07): 1754-1762 . 本站查看
    13. 张文京. 矿物掺合料抑制桥梁混凝土徐变和损伤发展的试验研究. 粉煤灰综合利用. 2020(06): 94-100 . 百度学术

    其他类型引用(11)

计量
  • 文章访问数: 
  • HTML全文浏览量: 
  • PDF下载量: 
  • 被引次数: 24
出版历程
  • 收稿日期:  2016-06-02
  • 修回日期:  2016-07-11
  • 刊出日期:  2017-04-14

目录

    /

    返回文章
    返回