Mg/NiTi复合材料的制备及阻尼性能

徐吉林; 陶寿晨; 肖奇飞; 罗军明; 张剑平; 刘勇

doi:10.13801/j.cnki.fhclxb.20180911.004

Mg/NiTi复合材料的制备及阻尼性能

1.
南昌航空大学材料学院, 南昌 330063;
2.
南昌大学江西省轻质高强结构材料重点实验室, 南昌 330031

基金项目: 国家自然科学基金（51101085）；航空科学基金（2015ZF56027；2016ZF56020）；江西省轻质高强结构材料重点实验室开放基金（20171BCD40003）

详细信息

通讯作者:
徐吉林,博士,副教授,硕士生导师,研究方向为形状记忆合金及粉末冶金,E-mail:jlxu@nchu.edu.cn

中图分类号: TG146.2
计量
- 文章访问数: 788
- HTML全文浏览量: 81
- PDF下载量: 256
出版历程
- 收稿日期: 2018-05-31
- 修回日期: 2018-07-04
- 刊出日期: 2019-03-14

Preparation and damping capacity of Mg/NiTi composites

1.
School of Materials Science and Engineering, Nanchang Hangkong University, Nanchang 330063, China;
2.
Key Laboratory of Lightweight and High Strength Structural Materials of Jiangxi Province, Nanchang University, Nanchang 330031, China

摘要

摘要: 采用Mg粉的无压熔渗法制备Mg/NiTi复合材料以提高多孔NiTi合金的强度和阻尼性能。通过OM、SEM、EDS和XRD分析Mg/NiTi复合材料的显微组织结构，采用压缩实验分析其抗压强度、吸能能力，采用热机械分析仪分析其内耗和存储模量。结果表明：经Mg粉无压熔渗后，多孔NiTi合金的孔隙被Mg填充，其孔隙率由原来的50.38%下降至5.6%，且Mg与NiTi合金的界面结合良好。多孔NiTi合金主要由B2奥氏体相和B19'马氏体相及少量Ni₃Ti相和NiTi₂相组成；Mg/NiTi复合材料除增加了熔渗的Mg相外，还新生成了Mg₂Ni相。Mg的渗入未改变多孔NiTi合金相变行为，但提高了相变温度。Mg/NiTi复合材料的抗压强度可达554 MPa，较多孔NiTi合金提高了61%，压缩断裂方式也由多孔NiTi合金的孔壁崩塌断裂转变为Mg/NiTi复合材料的剪切断裂。Mg/NiTi复合材料的吸能较多孔NiTi合金有大幅提高。同时，Mg/NiTi复合材料的内耗值有所增加，而存储模量大幅提高，整体呈现出更佳的阻尼性能。
- NiTi形状记忆合金 /
- 复合材料 /
- 无压熔渗 /
- 阻尼 /
- 能量吸收
Abstract: The Mg/NiTi composites were prepared by pressureless infiltration of Mg powders to improve the strength and damping capacity of porous NiTi alloys. The microstructure of the Mg/NiTi composites were investiaged by OM, SEM, EDS and XRD, the compressive strength and energy absorption ability were analyzed by compressive test and the internal friction and storage modulus were tested by the thermal mechanical analyzer. The results show that the pores of the porous NiTi alloy are filled by Mg through the pressureless infiltration of Mg powders, and the porosity decreases from 50.38% to 5.6% for Mg/NiTi composites. Moreover, the interface bonding of Mg and NiTi alloy is good. The porous NiTi alloys are mainly composed of B2 austenite phase and B19' martensite phase with a few Ni₃Ti and NiTi₂ phases, while the Mg/NiTi composites are composed of infiltrated Mg phase and newly generated Mg₂Ni phase except the phases contained in the porous NiTi alloys. The transformation behavior of the porous NiTi alloys does not change but the transformation temperatures increase after the infiltration of Mg. The compressive strength of the Mg/NiTi composites is up to 554 MPa, 61% higher than that of the porous NiTi alloys. The compression fracture mode also changes from the pore wall collapsed fracture of the porous NiTi alloy to the shear fracture of the Mg/NiTi composites. The energy absorption ability of the Mg/NiTi is greatly improved compared to the porous NiTi alloys. At the same time, the internal friction value of Mg/NiTi composites has a little increase, while the storage modulus is significantly improved, presenting much better damping capacity.
- NiTi shape memory alloy /
- composites /
- pressureless infiltration /
- damping /
- energy absorption

HTML全文

参考文献(0)

施引文献(17)

期刊类型引用(9)

1.	卢欢欢，王文广，李佩枫. SiO_2溶胶和CNTs杂化增强水泥基复合材料性能研究. 混凝土与水泥制品. 2023(03): 10-14 . 百度学术
2.	冯晓琳，杨旭东，安涛. 泡沫铝原位填充薄壁管的力学及吸能性能. 热加工工艺. 2022(16): 49-53 . 百度学术
3.	杨旭东，郑远兴，李威挺，肖冠宇，纵荣荣. Si元素对碳纳米管增强铝基复合泡沫组织与性能的影响. 复合材料学报. 2021(01): 186-197 . 本站查看
4.	林森，杨旭东，刘冠甫，胡琪，沙军威. 碳纳米管增强开孔铝基复合泡沫的疲劳性能. 复合材料学报. 2021(08): 2666-2675 . 本站查看
5.	张继旭，叶帆胜. 碳纳米管在水泥基复合材料中的分散方法研究. 建材世界. 2020(05): 6-9 . 百度学术
6.	何燕，敬成伟，侯朝兵，罗亮. 电弧法分散碳纳米管中不同金属电极的实验性研究. 功能材料. 2019(02): 2167-2172 . 百度学术
7.	杨旭东，成莹，郑远兴，安涛. 梯度泡沫铝的制备及力学性能研究进展. 热加工工艺. 2019(12): 16-20 . 百度学术
8.	李思超，杨旭东，安涛，郑远兴. 泡沫铝填充薄壁管复合结构压缩与吸能性能. 航空材料学报. 2019(05): 120-127 . 百度学术
9.	刘坤，王金，杜志元，沈鹏. 大深度载人潜水器浮力材料的应用现状和发展趋势. 海洋开发与管理. 2019(12): 68-71 . 百度学术