MICROSTRUCTURE OF THE HOLE SURFACE OF CFRP
-
摘要: 利用电子显微镜对碳纤维复合材料(单向) 孔壁表面微观形态进行了详细的观察分析, 首次得到了许多孔壁表面微观形态的SEM 照片, 并得出一些有益的结论。Abstract: A scanning electron microscope was used to observe the microstructure of the hole surfaces drilled on CFRP samples. SEM micrographs showed that some areas of the hole surface were covered with polymer while others were dominated by broken fibers. The latter increased with the increase of cutting speed. The roughness of the drilled surface also varied. The roughest parts located at the points where the fibers were fractured owing to bending shearing stresses. The broken face of each fiber was basically perpendicular to its own axis though the fibers broken by shearing appeared different with those by bending.
点击查看大图
计量
- 文章访问数: 1470
- PDF下载量: 803
- 被引次数: 0